薄膜生长的计算机模拟

薄膜技术在现代科技领域中有着广泛的应用。人们对薄膜的生长过程通过理论和实验进行了深入的研究，其中计算机模拟是重要的方法，本文概述了对薄膜生长过程的实验观察结果及其理论分析，主要讨论了薄膜生长的计算机模拟中经常采用的方法-蒙特卡罗法和分子动力学方法、描述衬底上成膜粒子运动的一些模型以及在计算机模拟中需注意的一些问题，其中主要包括粒子间的相互作用，入射粒子的能量和粒子上的衬底上的扩散运动。     

化学镀Ni-P合金/TiO2复合膜的耐蚀性研究

在改进常规制备方法的基础上，提出化学镀/溶胶-凝胶复合法在碳钢表面制备TiO2复合膜的新技术。用衍射研究了复合膜的组织形态，采用环境扫描电镜（ESEM）表征了复合膜的表观和断面形貌，用极化电阻、阳极极化曲线测量等方法研究TiO2复合膜在0.5mol/L硫酸和0.5mol/L氯化钠溶液中的耐蚀性能。结果表明A3钢表面的TiO2复合膜耐蚀性能优良。     

形成前处理对提高铝箔比容的影响

阳极氧化膜是电解电容器的工作介质，其质量的优劣直接影响着铝电解电容器的性能。若在形成前将腐蚀箔在７５℃左右的Ａ溶液（〔Ａ〕≈０．２ｍｏｌ／Ｌ）中浸泡约１０ｍｉｎ，然后在５７０℃左右热处理３ｈ，阳极氧化膜的结构与性能将得到改善，铝箔比容可提高２５％～５０％，而形成电能降低３０％～５０％，从而可有效提高形成效率。     

大环分子低维导体

本文综述了大环分子面－面堆积结构的准一维导体的结构、性质、导电机理、合成方法及研究进展。     

低银医用X光胶片的研制

对几种增黑剂进行了筛选实验研究，选用了两种增黑剂组合使用，提高了遮盖力，使医用Ｘ光胶片涂布银量由原业的９ｇ／ｍ２降到了６．８ｇ／ｍ２，与美国医用Ｘ光胶片涂布银量（６．７ｇ／ｍ２）相当，照相性能不低于国产医用Ｘ光胶片。     

聚乙烯包装薄膜形变性能与微观结构的研究

采用拉伸实验，研究形变速率对聚乙烯包装薄膜力学性能的影响。采用Ｘ射线衍射方法，分析聚乙烯薄膜形变后微观结构的变化，得到了形变后材料内部的微晶尺寸和点阵畸变值。     

Effect of rare-earth doping on the electrical and photoelectrical properties of furazano [ 3,4-b] piperazine (FP) thin-film devices

Schottky diodes of rare-earth, praseodymium (Pr)-doped and samarium (Sm)-doped furazano [3,4-b] piperazine (FP), sandwiched between Al and indium-tin oxide (ITO) were made by a spin-coating technique. The diodes, in which doped FP behaves as a p-type organic semiconductor, exhibit rectification behaviour. The p-type semiconductivity and rectification properties of the devices improve with rare-earth doping. The electrical effects observed in these devices are explained in terms of the p-type semiconducting behaviour of the doped FP thin films and the formation of a blocking contact (Schottky barrier) with the Al electrode and ohmic contact with the ITO electrode. Various electrical parameters such as carrier mobility, position of Fermi level, free carrier concentration, trap density, trap level and conductivity of doped FP are calculated and discussed. It is found that the position of the Fermi level shifts toward the valence band on rare-earth doping; concentration of free carriers and carrier mobility increase on doping. From the capacitance-voltage (C-V measurements, various electrical parameters such as barrier height, density of ionized acceptor atoms and depletion layer width are calculated and discussed. From the action spectra and absorption spectra it is confirmed that the Al-doped FP interface forms a Schottky barrier and the ITO-doped FP interface shows ohmic contact. The photovoltaic measurement on the two devices reveals that the short circuit current, open circuit voltage, fill factor and power conversion efficiency increase on rare-earth doping.     

Measurements of Stress Intensity Factors of an Interface Crack Under Mixed Mode Loading

The optical method of caustics has been utilised to measure both the stress intensity factor for a crack lying along the interface of an aluminium/epoxy bimaterial specimen, and the mode mixity arising from the difference in the elastic properties across the interface. Measurements were carried out by using a novel modification to the method whereby caustics are produced and measured from both sides of the specimen, so compensating automatically for the distortion induced in the specimen due to misaligned loading fixtures. A flat reflective surface across the interface was obtained by adhering a reflective coating to the specimen. Verification that this coating does not affect measurement accuracy was obtained by comparing stress intensity factors measured from coated and uncoated monolithic aluminium specimens where good agreement was found to exist between both measurements.     

水包油型多彩涂料的生产及施工

介绍了水包油型多彩涂料的组成、各组份的作用、生产工艺路线和工艺参数的选择。对多彩涂料的施工机具和方法作了简单介绍。